Customization
Servo Cutting System

Its cutter speed is 0.5-400/rpm, and instant speed is 50-150/rpm. It is mainly suitable for cutting large and long products in order to avoid blocking run situation.
Opening Barrel

Feeding at the rear-end of the machine,there is no need to open the ram head when feeding,and no need to take out the residual material of ram head,which can reduce the intensity of labor an improve the productivity.It is suitable for mass production.
Telescopic Conveyor

the weight of rubber blanks during the beginning performing is not stable, when the accuracy of the rubber blank meets your criterion ,press the button to force the conveyor move forward ,and the counting will start on the touch screen.This will effectively distinguish between qualified and unqualified rubber blanks.
The head Part Covered With Stainless Steel

compared with traditional spraying process,it is can avoid the contamination caused by peeling paint,and make it convenient to clean.
The Frame Plate Is Covered With Stainless Steel

compared with traditional spraying process,it is Completely can avoid the contamination caused by peeling paint,and make it convenient to clean.
Fixed Length Cutting System

Fixed length cutting is the combination of light sensing control and cutting knife control,which can effective control of the length of rubber strip,It is mainly used for filter cutting of Silicone Compound, and the use of supply injection machine, and other related uses.
Alarm Device: Alarm Device

alarm when device malfunction happens,also can set reminding time with touch screen to remind the workers to random inspect the weight of the rubber blank on time.
Barcode Scanner

Scanning the bar code of the production process, allowing the process parameters to be invoked directly.it is operation visualization to avoid data errors by workers.
Data Interface

RS232 and other data interfaces are provided to facilitate the connection of equipment and ERP and other management systems to realize modern management.
Displacement Sensor

The front stop and back stop position of the ram can be set on the Touch screen according to production capacity ,also display the remaining material on the touch screen, It not only improves production efficiency, but also increases the degree of visualization.
Automatic Hydraulic Door Card Buckle

It is hydraulic drive to open and close the buckle,Compared with the traditional manual opening and closing, it is easier, safer, less efficient and more efficient.
Device Of Reducing Residual Material

The residual material on the ram head is further reduced to make the utilization rate of rubber material is higher. Also because the taper structure leads to the uneven compression of the rubber, the deviation of the weight accuracy is greater than that of the standard ram head.

Solution
Product Catalog